12,000 Watt 6′ x 12′ Bodor 4020 Fiber Laser, 2022 – Lots of Extras and Perks (Read The Specs)

Table Size: 6′ × 12′ (2000 × 4000 mm) Laser Power: 12,000 Watt Table Load Capacity: 2500 kg (5,500 lb) Cutting Speed: 169 m/min (6,653 in/min) Accuracy Positioning: ±0.05 mm, Repeatability ±0.03 mm Z-Axis Travel: 315 mm (~12.4″) Shuttle Exchange: 16 seconds Approx. Machine Size: 472″ × 146″ × 91″ Approx. Weight: 11,000 kg (24,200 lb)

All specifications are assumed to be correct but must be confirmed by the purchasing entity.,Additional add ons and services Included:

All specifications are assumed to be correct but must be confirmed by the purchasing entity.,Updated Cutting head Air cutting system with 220PSI compressor, refrigerated dryer, 2X 1000l tanks mounted on a skid with additional desiccant dryer, multi stage air filtration. Dust collector with spare filter cartridges Chiller

All specifications are assumed to be correct but must be confirmed by the purchasing entity.,Spare parts Cart (see pictures) Range of nozzles from 1.4mm to 5mm Protective lenses Ceramic nozzle adapters Upper lense set New Capacitance Sensor (Spare) New lower unit for cutting head (Spare)

All specifications are assumed to be correct but must be confirmed by the purchasing entity.,Clean Flow box for head service

All specifications are assumed to be correct but must be confirmed by the purchasing entity.,15 Shelf Material storage tower, Built in house. Shelves can hold 6×12 size sheets and smaller.

All specifications are assumed to be correct but must be confirmed by the purchasing entity.,Spare blower motor for dust collector- Unused

All specifications are assumed to be correct but must be confirmed by the purchasing entity.,The machine has been running without down time all year only issue we had was with the chiller and that was replaced with a brand new unit. Machine is used daily and will be kept under power until new machine is installed.

All specifications are assumed to be correct but must be confirmed by the purchasing entity.,Pick up location is Willing to provide training at our facility before decommissioning. – settings and cut parameters, maintenance and software use.

All specifications are assumed to be correct but must be confirmed by the purchasing entity.