1 - used L&F HUFFORD CNC EXTRUSION STRETCH WRAP FORMING MACHINE
Model A-5, Serial Number 81127-1



DeMott Controls Model D2732-001, Serial Number 2732-2

FORMING TONNAGE 12
JAW AXIAL ROTATION +/- 180 Degrees
DISTANCE BETWEEN JAWS:
Max Length of Part w/ Tension Cylinders fully retracted 115" (2,921 mm)
Min Length of Part w/ Tension Cylinders fully extended 12" (304.8 mm)
TENSION CYLINDER STROKE (Adjustable) each 20" (508 mm)
TENSION CYLINDER PULL (Adjustable) 600 lbs. to 12 Tons
TENSION CYLINDER SPEED Retracted & Extended, No Load, one Cylinder 1-40 ipm

TENSION CYLINDER SWING (Horizontal Elongation) +/- 30
ARM SWING (each Arm has Independent Movement) 10 Forward to 90 Back.
WRAPPING SPEED RANGE Adjustable
DIE LENGTH at FULL TONNAGE and 180 degrees Wrap adjustable:
Minimum.................... 11" (279.4 mm)

Maximun ................... 40" (1,016 mm)
DIE TABLE: 42 Pre drilled & 5/8" threaded
Working Surface, W x D 42"FB x 44_" LR (1,066.8 mm x 1,136.65 mm)
Height Table To Floor 36" (914 mm)


MOTOR DRIVE: Wired 460 volts, 3 Phase
Hydraulic Pump 30 H.P. 230/460 volts
Joggler Pump 7 H.P. 230/460 volts
Two Arm Adjustment each1/2 H.P. 230/460 volts


CONTROLS: DeMott CNC Controls with: Programmable Key Pad, CRT, and hand

function buttons.

REMOTE HAND CONTROLS located on each arm with 2-Tension Cylinders, In/Out push

buttons, Ten Cylinder Load and Stop Push Buttons. Jaw Close / Open Switch.

Carriage In / Out Switch.

EQUIPPED WITH:
1-set of 4" Jaws with Hydraulic Clamping.
1-set Adjustable Die Post 4" diameter x 11" Ht.
Farval Centralized Lubrication System SS-4200.
Thermal Transfer Products Heat Exchanger.
Complete factory safety guards

Dimensions Former 60" FB x 128" LR
Pump & Electrics 60" FB x 84" LR