NEW SHARP SVG-9943A-F GEAR HEAD CNC VERTICAL MACHINING CENTER
- Meehanite cast iron is used on all structural components.
- The column uses a "Y" shaped base for extra rigidity to resist heavy machining forces.
- Counter Balance on "Z" Axis - the massive spindle head uses a counter balance with guide rails.
- A wide saddle fully supports the worktable throughout the travel
- The base is a rigid one piece casting. Heavy internal ribs are used throughout the machine structure.
- The base casting is wider and deeper than most others. This gives more stability during rapid movements and heavy cutting.
- All guideways are induction hardened then precision ground.
- Turcit B bonded to all sliding surfaces. Oil grooves are machined and then it's hand scraped to produce an excellent bearing surface.
- Each axis is driven by a high precision double-nut ball screw that is centered between the guide ways. The ball screws are pretensioned and anchored at both ends with angular contact thrust bearings.
- Both sides of the machine enclosure have large removable doors. The door openings are large enough to allow full "Y" axis travel with long workpieces extending through the sides.
| Box Way Gearhead Vertical Machining Center |
SVG-9943A-F |
| Travel Size (x, y, z) (displayed in inches) |
99.3 x 43.3 x 34.4 |
| Table Size (displayed in inches) |
106.3 x 39.4 |
| Table Load (lbs.) |
7,718 lbs |
| T Slots (Num x Width x Pitch)(inches) |
6 x 0.86 x 6.3 |
| Spindle Nose to Table (inches) |
9.5 - 44.5 |
| Spindle Center to Column (inches) |
41.3 |
| Spindle Speed (standard) (rpm) |
30 - 6,000 |
| Taper |
CAT 50 |
| Transmission (Direct) |
2 Speed Gear |
| Spindle Motor cont./30mins (hp) |
30/35 hp |
| Rapid Traverse (x,y) (ipm) |
315 |
| Rapid Traverse (z) (ipm) |
315 |
| Tool Change System Capacity (Arm Type) |
40 |
| Max Tool Diameter (inches) |
2.95 |
| Max Tool Weight (lbs.) |
15.4 |
| Max Tool Length (in.) |
11.8 |
| CNC Control (Fanuc) |
0i MD |
| Positioning Accuracy |
±.0003” |
| Repeatability Accuracy |
±.0002” |
| General Power |
220/3/60 |
| Air Requirement (psi) |
100 |
| Dimensions and Weight |
|
| Machine Dimensions |
320” x 203” x 154”
|
| Net weight |
52,800 lbs. |
STANDARD ACCESSORIES
- Full metal enclosure
- Auto-lubrication system with alarm
- Rigid tapping
- Coolant gun, air gun
- Spindle oil cooler
- M code air blast
- Heat exchanger for electric cabinet
- 148 gallon roll out coolant tank
- Auger at 2 sides of machine base
- Chip flushing system
- Coolant Through Spindle prepped
- 4th axis prepped
|
No files or videos to display
